SW-393 Datasheet | Tyco Electronics

Features - - - - - Terminated RF Output High Isolation: 42 d B up to 2.0 GHz Single Positive Control CMOS patible Logic SOIC-8 Plastic Package SW-393 V4 Functional Schematic Description M/A-’s SW-393 is a Ga As monolithic SPST terminated switch in a low cost SOIC 8-lead plastic package. The SW-393 is ideally suited for use where low power consumption and high isolation are required. Typical applications include PCS and GSM LO Switching, switch matrices and switched filter banks in systems such as radio and cellular equipment. The SW-393 is fabricated using a mature 1-micron gate length Ga As MESFET process. The process features full chip passivation for increased performance and reliability. Pin Configuration 4 Pin No. 1 2 3 4 Ordering Information 1 Part Number SW-393-PIN SW-393TR SW-393SMB Function GND RF1 GND GND Pin No. 5 6 7 8 Function GND CTL RF2 GND Package Bulk Packaging 1000 piece reel Sample Board 4. Blocking capacitors are required on all RF ports. VS can be applied at RF1 or RF2 using 10K or greater pull-up resistors. 1. Reference Application Note M513 for reel size information. Absolute Maximum Ratings 2,3 Parameter Input Power Operating Voltage (VS, VCTL) Operating Temperature Storage Temperature Truth Table 5,6,7 Control 0 1 5. 6. 7. “0” = 0 ± 0.2 VDC “1” = +5 ± 0.2 VDC Vs = +5 ± 0.2 VDC Absolute Maximum +34 d Bm +8.5 Volts -40°C to +85°C -65°C to +150°C RF1 - RF2 Off On 2. Exceeding any one or bination of these limits may cause permanent damage to this device. 3. M/A- does not remend sustained operation near these survivability limits. M/A- Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A- makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A- assume any liability whatsoever arising out of the use or application of any product(s) or information. - North America Tel: 800.366.2266 /...